Jul 28, 2023 · True, it is innovative. But telling people…..”this is great, except due to the excessive overhang and out of balance condition, you might have to spend $20,000 on a lathe upgrade”. …

Jul 28, 2023 · True Bore Alignment System Review First off, let me give Nathan Dagley genuine kudos for developing a truly innovative product for gunsmithing, as well as a rather …

Jul 28, 2023 · I invested in the True Bore because my lathe’s primary use is not chambering barrels. It’s headstock is long and does not allow the use of more common practices like …

Jul 28, 2023 · The True Bore Alignment system was engineered and has always been manufactured here at Straight Shot Gunsmithing." Seems to work. Just as a side note, doing a …

Jul 28, 2023 · In my experience, if you go to the true bore alignment website and read the process as documented for truing the bore with their range rod, I would say that the true bore …

Jul 28, 2023 · What is flexing? I use a tbas with a tmx 6 jaw. I can indicate the barrel in, drill, bore, then check the bored hole, and a .0001 indicator and it doesnt wiggle. The chamber throats …

Jul 28, 2023 · Over the last +11 years, I have had SSG chamber & crown 9 barrels, all of which were done in his True-Bore Alignment System on Haas TL1 CNC Lathes. The simplicity of the …

Jul 28, 2023 · I invested in the True Bore because my lathe’s primary use is not chambering barrels. It’s headstock is long and does not allow the use of more common practices like …

Mar 24, 2014 · Well, I drilled some half inch holes in the TBAS, but it didn't really do much, however I did run it at 1250 rpm and it has much less propensity of chatter at the higher rpm …

Dec 27, 2022 · Any of you guy use the tru bore alignment system???